hil_set_analog_output_ranges hil_set_clock_mode navigation bar

Table of Contents

hil_set_clock_frequency

Deprecated

The HIL API MATLAB functions have been deprecated in favour of the new quanser.hardware.hil class, which has support for code generation for Quanser targets. Hence, with the new hil class it is possible to run MATLAB scripts in real-time on Quanser targets, while making use of the Quanser hardware.

Sets the frequencies of the specified hardware clocks.

Syntax

err = hil_set_clock_frequency(board, clocks, frequencies)
    

Description

Configures the frequencies of the specified hardware clocks. Not all boards support configuration of the hardware clock frequencies. The driver for the board will round the given frequencies to the nearest achievable values.

If no err output is provided then it throws an exception if an error occurs. In generated code it prints the error message. Use hil_get_error_message to get the message associated with an error code.

Parameters

board

The board handle returned by hil_open.

clocks

A vector of clock numbers. Clock numbers are zero-based.

Select a board type from the list for board-specific details: .

frequencies

A vector specifying the clock frequencies. There must be one element for each clock in the clocks vector. If a value of zero is specified then the corresponding clock is disabled.

Outputs

err

A negative error code or zero on success.

Examples

% Sets frequencies of hardware clocks 0, 3 and 5 to 10 kHz, 1 MHz and 100 kHz respectively.
hil_set_clock_frequency(board, [0 3 5], [10e3 1e6 100e3]);
    

See Also

 

navigation bar