Table of Contents
Owning Palette: | Not available in this version of RCP Toolkit. Please check for updates. |
Requirements: | Quanser Rapid Control Prototyping Toolkit, LabVIEW 2020 or newer |
The Stream Set Swap Bytes VI configures whether the stream should swap bytes between little endian and big endian byte ordering when sending and receiving data. Streams take into account the data types being sent and received and can swap the byte order when communicating with peers of a different endianness.
stream in is a reference to the stream to configure for swapping bytes. |
Whether to swap the byte order of data types (from little-endian to big-endian or vice versa) when sending and receiving data over the stream. |
error out contains error information. If the error in cluster indicated an error, the error out cluster contains the same information. Otherwise, error out describes the error status of this VI.
|
All input/output pairs of this function have direct feedthrough behaviour.
There are currently no examples
Target |
Supported |
Comments |
---|---|---|
Yes |
Fully supported. |
Copyright © Quanser Inc. This page was generated 2021-09-24. Submit feedback to Quanser about this page.
Link to this page.