Multiwii Write RC Tuning

Writes RC tuning parameters to the auto-pilot.

Library

QUARC Targets/Communications/Multiwii

Description

The Multiwii Write RC Tuning block uses the Multiwii protocol on the input stream to send a command to the aircraft to write RC tuning parameters to the auto-pilot. The Multiwii Write RC Tuning block sends a MSP_SET_RC_TUNING message to the auto-pilot.

This block is designed to be used with blocking I/O. It is typically used with a stream connected to a serial port. To open the stream a Multiwii Connect block should be used.

The inputs of the block are the RC tuning parameters expressed as percentages. In particular, there is the RC rate, the RC exposition, the roll-pitch rate, the yaw rate, the dynamic throttle PID, the throttle mid-range and the throttle exposition.

A copy of the stream is also output so that the Multiwii blocks may be chained together.

If an error occurs, then the block returns a negative error code at its err output. The Compare to Error block may be used to check for specific error codes. If the stream is not valid because it is not yet connected, the err output will be zero since this condition is expected and the validity of the stream may be checked using the con output of the Multiwii Connect block.

Helpful Hints

Other uses of this block

Although it is intended for use in the main diagram with the other Multiwii blocks, the Multiwii Write RC Tuning block may be used with the Advanced stream blocks, even in an asynchronous thread.

Input Ports

stm

A reference to the stream created by the Multiwii Connect block. If a connection has not yet been established, then the err output of the Multiwii Write RC Tuning block will be zero.

rc_rate

A double scalar representing the RC rate, as a percentage between 0 and 1.

rc_expo

A double scalar representing the RC exposition, as a percentage between 0 and 1.

roll_rate

A double scalar representing the roll-pitch rate, as a percentage between 0 and 1.

yaw_rate

A double scalar representing the yaw rate, as a percentage between 0 and 1.

dyn_pid

A double scalar representing the dynamic throttle PID, as a percentage between 0 and 1.

thr_mid

A double scalar representing the throttle mid-range, as a percentage between 0 and 1.

thr_expo

A double scalar representing the throttle exposition, as a percentage between 0 and 1.

Output Ports

stm

A reference to the stream. This output is merely a copy of the stm input. Providing this output makes it much easier to establish the execution order of Multiwii blocks in the diagram because Simulink generally executes daisy-chained blocks in sequence.

err

An int32 value indicating whether the message was sent successfully. This value will be positive if message was sent successfully. It will be zero if no message was sent. If an error occurs then this value is a negative error code. See Error Codes for the different error codes and their values. Use the Compare to Error block rather than the error code itself to check for specific error codes. To check for errors in general use the Compare to Zero block to check whether the err output is less than zero.

Parameters and Dialog Box

Write only when the input changes

Check this option to have the block only write new RC tuning parameters when the input changes. If this option is not checked then the block will write new RC tuning parameters every time it executes.

This option makes it easier to use the block, since it typically makes a Triggered Subsystem unnecessary when the option is checked.

Targets

See Also

• Multiwii Connect block
• Multiwii Communications

Copyright ©2024 Quanser Inc. This page was generated 2024-04-16. Submit feedback to Quanser about this page.

Link to this page.