Table of Contents
Roomba Wait Angle
Waits until Roomba has rotated through the specified angle in degrees.
Library
MATLAB Command Line
Click to copy the following command line to the clipboard. Then paste it in the MATLAB Command Window:
qc_open_library('quarc_library/Devices/Third-Party/iRobot/Roomba/Interfacing')Description
The Roomba Wait Angle block causes the robot to wait until it has rotated through specified angle in degrees. When Roomba turns counterclockwise, the angle is incremented. When Roomba turns clockwise, the angle is decremented. Until Roomba turns through the specified angle, its state does not change, nor does it react to any inputs, serial or otherwise.
This command is available in Passive, Safe, or Full operating mode of Roomba (see Roomba Modes block). Execution of this command does not change current Roomba operating mode. This command resets the angle variable that is returned by Roomba Sensor Request, Roomba Query List, and Roomba Sensor Stream blocks.
Important Notes
Use System Timebase block in Normal simulation.
Input Ports
rmb
A reference to the Roomba stream (see Roomba Initialize block).
vel
16-bit signed velocity in mm/s. The maximum forward and backward velocities are 500 mm/s and -500 mm/s, respectively.
rad
16-bit signed radius of curvature in mm. The maximum counterclockwise and clockwise radii of curvature are 2000 mm and -2000 mm, respectively.
Special cases:
ang
16-bit signed angle in degrees.
Output Ports
rmb
A reference to the Roomba stream, which is the same as input Roomba stream reference. It helps creating a daisy chain of Roomba blocks.
err
Parameters and Dialog Box
Sample time
The sample time of the block. A sample time of 0 indicates that the block will be treated as a continuous time block. A positive sample time indicates that the block is a discrete time block with the given sample time. A sample time of -1 indicates that the block inherits its sample time.
Targets
Target Name |
Compatible* |
Model Referencing |
Comments |
---|---|---|---|
Yes |
Yes |
||
Yes |
Yes |
||
Yes |
Yes |
||
Yes |
Yes |
||
Yes |
Yes |
||
Yes |
Yes |
||
Yes |
Yes |
||
Yes |
Yes |
||
Yes |
Yes |
||
Yes |
Yes |
||
Yes |
Yes |
||
Yes |
Yes |
||
Yes |
Yes |
||
Yes |
Yes |
Last fully supported in QUARC 2018. |
|
Rapid Simulation (RSIM) Target |
Yes |
Yes |
|
S-Function Target |
No |
N/A |
Old technology. Use model referencing instead. |
Normal simulation |
Yes |
Yes |
Use System Timebase. |
See Also
Copyright ©2024 Quanser Inc. This page was generated 2024-10-17. Submit feedback to Quanser about this page.
Link to this page.