Quanser Communications Toolbox (qccomm) End of trail navigation bar

Table of Contents > QUARC > Getting Started with QUARC > Migrating From WinCon > Where Did Those Blocks Go? - Migrating WinCon Blocks to QUARC

WinCon Toolbox (wctools)

The WinCon Toolbox provides some extra sinks in addition to the standard Quanser Toolbox. This section describes the migration path from those sinks to equivalent blocks in QUARC, if available.

Thermometer

The Thermometer block is not supported in QUARC. It will likely not be included in a future release of QUARC due to very low demand.

X-Y Graph

The X-Y Graph block is provided in QUARC as the XY Figure block. While the X-Y Graph block supplied with Simulink (as opposed to the WinCon block) actually does work in QUARC, it's performance is extremely poor. The XY Figure block provided in QUARC has much higher performance and is more flexible. In particular, it supports multiple traces on the same plot, which the X-Y Graph block does not. The XY Figure block is found under the

QUARC Targets/Sinks/Figures

MATLAB Command Line

Click to copy the following command line to the clipboard. Then paste it in the MATLAB Command Window:

qc_open_library('quarc_library/Sinks/Figures')
library.

 

navigation bar