Table of Contents
RCP myRIO-1900 Target
One of the target types supported by the RCP Toolkit is the RCP myRIO-1900 Target.
Description
The RCP myRIO-1900 Target is a hard real-time target, based on LabVIEW Real-Time.
The RCP myRIO-1900 Target supports, for example, the Quanser Terminal Board for NI myRIO configuration as illustrated below and detailed in the Hardware Requirements and NI myRIO Module Configurations Requirements sections.
Hardware Requirements
The RCP myRIO-1900 Target currently supports the following model.
NI myRIO Module Configurations Requirements
Depends on the version of the RCP myRIO-1900 Target, the following configurations and modules are available.
Software Requirements
The software requirements to use LabVIEW and the RCP toolkit on the RCP myRIO-1900 Target are:
(*)
(*)
(*)
[only used in certain Quanser curriculum VIs]
(*) - The version of the module or feature on the cRIO must correspond to the version of LabVIEW installed on the host.
Copyright © Quanser Inc. This page was generated 2021-09-24. Submit feedback to Quanser about this page.
Link to this page.