RCP myRIO-1950 Target

One of the target types supported by the RCP Toolkit is the RCP myRIO-1950 Target.

Description

The RCP myRIO-1950 Target is a hard real-time target, based on LabVIEW Real-Time.

Hardware Requirements

The RCP myRIO-1950 Target currently supports the following model.

NI myRIO-1950 Board Only

NI myRIO Module Configurations Requirements

Depends on the version of the RCP myRIO-1950 Target, the following configurations and modules are available.

Software Requirements

The software requirements to use LabVIEW and the RCP toolkit on the RCP myRIO-1950 Target are:

• LabVIEW Real-Time Module (*)
• LabVIEW Control Design and Simulation Module (*)
• Optional: LabVIEW MathScript RT Module (*) [only used in certain Quanser curriculum VIs]
• NI Device Drivers Reconfigurable I/O (RIO) (*) Feature
• NI Device Drivers Real-Time and Embedded (*) Feature
• RCP Toolkit for myRIO, see Installing RCP on the NI myRIO

(*) - The version of the module or feature on the cRIO must correspond to the version of LabVIEW installed on the host.

Copyright © Quanser Inc. This page was generated 2021-09-24. Submit feedback to Quanser about this page.

Link to this page.